EDITOR PICKS

The future of vacuum oil quenching

July 15, 2024

The effect of heat treatment on a 3D-printed PLA polymer’s mechanical...

June 15, 2024

Optimal fabrication of a thin-film thermocouple using Alumel/Chromel junctions

May 15, 2024

Editor Picks

Low pressure carburization modeling with carbide formation and dissociation

October 15, 2020

Typical Heat Treatment Defects of Gears and Solutions Using FEA Modeling

April 5, 2013

4D high-pressure gas quenching

July 15, 2020

Temperature uniformity survey ( TUS ) general practice for CQI-9 and AMS2750E

March 15, 2020

Understanding the Jominy end quench test

January 15, 2020

Troubleshooting and Prevention of Cracking in Induction Hardening of Steels: Lessons Learned –...

September 15, 2019

Operational efficiencies and minimizing energy consumption: An introduction

October 11, 2019

The future of kiln lining fibers

February 15, 2019

Temperature uniformity survey ( TUS ) general practice for CQI-9 and AMS2750E

March 15, 2020

Popular Columns

Increased Productivity Combining C/C Fixturing and LPC

April 17, 2014

Temperature sensor selection: The basics of temperature measurement using thermocouples

May 15, 2020

Simulation of Gas Quenching of Steel Parts

September 13, 2013

2024 Annual Meeting was a success

Aqueous inorganic salt quenchants

Alessandra Palombi wins Aichelin Young Speaker Award

Inducing heat treatment for case hardening

Commercial Heat Treaters

Equipment

Marketplace

Services

AjaxTOCCO

EDITOR PICKS

The future of vacuum oil quenching

The effect of heat treatment on a 3D-printed PLA polymer’s mechanical...

Optimal fabrication of a thin-film thermocouple using Alumel/Chromel junctions

Editor Picks

Low pressure carburization modeling with carbide formation and dissociation

Typical Heat Treatment Defects of Gears and Solutions Using FEA Modeling

4D high-pressure gas quenching

POPULAR POSTS

Temperature uniformity survey ( TUS ) general practice for CQI-9 and AMS2750E

Understanding the Jominy end quench test

Troubleshooting and Prevention of Cracking in Induction Hardening of Steels: Lessons Learned –...

Popular Articles

Operational efficiencies and minimizing energy consumption: An introduction

The future of kiln lining fibers

Temperature uniformity survey ( TUS ) general practice for CQI-9 and AMS2750E

POPULAR CATEGORY

Popular Columns

Increased Productivity Combining C/C Fixturing and LPC

Temperature sensor selection: The basics of temperature measurement using thermocouples

Simulation of Gas Quenching of Steel Parts