EDITOR PICKS

The role of in-situ techniques in microstructure optimization of interstitially alloyed...

December 15, 2024

Optimization of the de-bind cycle of sinter-base additive manufactured 17-4 components

September 15, 2024

Purpose-built forged parts optimized for ‘end use’

August 15, 2024

Editor Picks

Heat-transfer fluids: Growing in visibility and importance

February 15, 2022

Operational efficiencies and minimizing energy consumption: An introduction

October 11, 2019

Freezing Out the Competition

January 15, 2019

Understanding the Jominy end quench test

January 15, 2020

Temperature uniformity survey ( TUS ) general practice for CQI-9 and AMS2750E

March 15, 2020

Troubleshooting and Prevention of Cracking in Induction Hardening of Steels: Lessons Learned –...

September 15, 2019

Experimental research of a small-scale industrial furnace with regenerative disc-flame burners

February 15, 2024

Heat Treatments and Critical Quenching Rates in Additively Manufactured Al–Si–Mg Alloys

July 15, 2020

Nitrogen gas quenching pressure effect on BS S155 alloy steel in...

July 15, 2024

Popular Columns

A Case for Acetylene Based Low Pressure Carburizing of Gears

October 29, 2012

Take Another Look at Deep Cryogenic Treatment

January 15, 2020

Recent Inventions and Innovations in Induction Hardening of Gears and Gear-like...

April 5, 2013

Cleaning for heat treatment – Part II

IHEA’s Inaugural Decarbonization SUMMIT a success for attendees

Q&A with Veronica Becker

Leading heat-treatment computer simulation expert dies

Commercial Heat Treaters

Equipment

Marketplace

Services

TP-2022-02 Feat 1 Figure7